⚠️ Recommended Soldering Iron Temperature when soldering is 240 Celsius (464 Fahrenheit).
Controllers are heat sensible and fragile components, please handle with care.
⚠️When soldering the nice!nano, avoid using high iron temperatures or irons without temperature control, as you could damage the main nRF52840 chip. A temperature around 270°C-300°C should be hot enough. The higher the temperature, the more likely you are to damage the board.⚠️
Nice!Nano is a replacement for the popular Pro Micro controller and made to turn your keyboard wireless using ZMK software.
Flashing nice!nano is as easy as a drag and drop.
- How compile ZMK Firmware and flash Nice!Nano Controller (Step by Step Guide)
- Works wirelessly using Li-Po Battery or wired via USB-C cable.
- Nice!Nano Docs
- ZMK Docs
- Nice!Nano Discord community
- ZMK Discord community
- USB-C socket
- Microcontroller Nordic nRF52840
- 3.3 V operating voltage
- Quiescent Current ~20μA
- 1MB Flash
- 256KB RAM
- 4.2V Lithium @ 100/500 mA rate Battery Charging
- 21 GPIO Pins
- UF2 bootloader
- 3.2mm thick
- Includes 2x 12 pin headers
Please read the documentation before usage.
Electrically and physically compatible with the standard Pro Micro.
For more info check Nice!Nano FAQ page.
⚠️ Warning: you’ll need to understand how to use this hardware and it’s software to use it properly. You will need to know how to use a command line and which polarity of your battery goes to which pin on the controller. Failing these may result in fire/explosion and other damages. Please read the documentation on how to use this product.
Product on photography is illustrative and for demonstration purposes only. Received product might look different, while it is still the same.